Cases
How to Connect Wires to Tullker Generator
admin
2023-08-15 18:36:22
0

Wire Connection of Generator

Please cut off the power supply before wiring.


Step 1: unscrew the back cover with a screwdriver.


Step 2: thread the red wire marked "+" through the first hole in the back cover.


And thread the blue wire marked "-" through the second hole in the back cover.

 

Step 3: connect the red wire to the first connector and tighten it by a screwdriver.


Step 4: connect the blue wire to the third connector and tighten it.


Step 5: thread the third hole and the fourth hole of the back cover respectively with the remote control wires.


Note: remote control wires have no positive or negative terminals.


Step 6: connect the two remote wires to the rear panel by a screwdriver.


Step 7: close the back cover and tighten the screws.